User's Manual

2
OFF WLAN off
ON WLAN link / active
Wireless
LAN
WLAN
Green
Blinking WLAN traffic transmitting
ON Power on
OFF Power off
Power
WPS
Power
WPS
Green
Blinking
WPS is enabled to make a
connection
Rear Panel
Ports and buttons
Ant.
Install the appending antenna here.
WPS
To enable the WPS function via web configuration (Go to
Wireless Settings> WPS), then press the physical WPS button
on the Wireless Router once, then the LED will start to flash.
Please make a connection with other WPS supported device
within 2 minutes.
Reset
Keep on pressing the Reset button more than 3 seconds, the
Wireless Router will set all setting back to factory default values.
LAN 1-4
Use standard LAN cables (RJ45 connectors) to connect your PCs
to this port. If required, any port can be connected to another hub.
Any LAN port will automatically function as an "Uplink" port when
necessary.
Internet
Connect the ADSL or Cable Modem here with RJ45 cable. If your
modem came with a cable, use the supplied cable, otherwise, use
a standard LAN cable (RJ45 connectors).
DC 12V
Connect the supplied power adapter here.