User Manual

18
Wireless
Basic Settings
This page is used to configure the parameters for wireless LAN clients which may connect to
your Access Point. Here you may change wireless encryption settings as well as wireless
network parameters.
Disable Wireless
LAN Interface
Check to disable the Access Point function.
The wireless (WLAN) LED on front panel will remain OFF if the
Wireless interface is disabled.
Band
You can choose one mode of the following you need.
z 2.4GHz (B): 802.11b supported rate only.
z 2.4GHz (G): 802.11g supported rate only.
z 2.4GHz (N): 802.11n supported rate only.
z 2.4GHz (B+G): 802.11b supported rate and 802.11g supported
rate.
z 2.4GHz (G+N): 802.11g supported rate and 802.11n supported
rate.
z 2.4GHz (B+G+N): 802.11b, 802.11g and 802.11n supported
rate.
The default is 2.4GHz (B+G+N) mode.