User Manual

performance instead of providing a remedy.

This value should remain at its default setting of 2347. Should you encoun-

ter inconsistent data flow, only minor modifications of this value are

recommended.

Beacon Interval

Beacon Interval is the amount of time between beacon transmis-

sions. Before a station enters power save mode, the station needs the

beacon interval to know when to wake up to receive the beacon.

Range 20-1024 ms, default is 100.

Preamble Type

A preamble is a signal used in wireless environment to synchronize

the transmitting timing including Synchronization and Start frame

delimiter. You can select Long or Short for the preamble type.

IAPP

Select Enabled or Disabled to execute this function.

Protection

Select Enabled or Disabled to execute the security function.

Aggregation

Select Enabled or Disabled to execute this function.

Short GI

Select Enabled or Disabled to execute this function.

RF Output Power

Select the transmitting power rate 100%, 50%, 25%, 10% or 5%.

Apply changes After completing the settings on this page, click Apply changes

button to save the settings.

Reset Click Reset to restore to default values.

Security

Here you can configure the security of your wireless network. Selecting different method will

enable you to have different level of security. Please note that by using any encryption, by

which data packet is encrypted before transmission to prevent data packets from being eaves-

dropped by unrelated people, there may be a significant degradation of the data throughput on

the wireless link.

Select SSID

Select the preferred AP from pull-down list.

Apply changes After completing the settings on this page, click Apply changes