User Manual

25
Delete All
Click Delete All to delete all the items.
Reset
Click Reset to rest.
WDS Settings
Wireless Distribution System uses wireless media to communicate with other APs, like the
Ethernet does. To do this, you must set these APs in the same channel and set MAC address of
other APs which you want to communicate with in the table and then enable the WDS. If you
would like to setup this WDS function, please go to Wireless Basic Settings, and then select
the Mode into WDS mode.
Enable WDS
Check the box to enable the WDS function.
MAC Address
MAC Address: Enter the Wireless BSSID (MAC) of the wireless AP
that you want to connect with. To check your wireless router’s MAC
address, please go to Management > Status tab to find your MAC
address.
Data Rate
Select the data rate form the pull-down list.
Comment
Enter a description for the device.
Apply Changes After completing the settings on this page, click Apply changes button
to save the settings.
Reset Click Reset to restore to default values.
Set Security Enable the WDS function and then click Set Security button to set up
the WDS security.