User Manual

26
WDS Security Setup
Encryption: Select the encryption type None, WEP 64 bits, WEP 128
bits, WPA (TKIP) and WPA2 (AES) from the pull-down menu.
WEP Key Format: For WEP 64 bits and WEP 128 bits encryption
type, the selection of WEP Key Format are Hex and ASCII.
WEP Key: If select Hex if you are using hexadecimal numbers (0-9, or
A-F). Select ASCII if you are using ASCII characters (case-sensitive).
z Hexadecimal (WEP 64 bits): 10 Hex characters (0~9, a~f).
z Hexadecimal (WEP 128 bits): 26 Hex characters (0~9, a~f).
z ASCII (WEP 64 bits): 5 ASCII characters (case-sensitive).
z ASCII (WEP 128 bits): 13 ASCII characters (case-sensitive).
Pre-Shared Key Format: The Pre-shared Key Format will be
enabled when WPA (TKIP) and WPA2 (AES) encryption be selected.
There are two formats for choice to set the Pre-shared key, Passphrase
and Hex (64 characters). If Hex is selected, users will have to enter a
64 characters string. For easier configuration, the Passphrase (at least 8
characters) format is recommended.
Pre-Shared Key: Pre-Shared-Key serves as a password. Users may key
in 8 to 63 characters string to set the passwords or leave it blank, in
which the 802.1x Authentication will be activated. Make sure the same
password is used on client's end.
Apply Changes: Press to save the new settings on the screen.
Close: Click to leave the screen.
Reset: Click to restore the screen.
Show Statistics
Click to show the current WDS AP table. This table shows the MAC
address, transmission packets and errors, reception packets and Tx Rate
(Mbps) counters for each configured WDS AP.