User Manual

29
TCP/IP Settings
LAN Interface
This page is used to configure the parameters for local area network which connects to the
LAN port of your Access Point. Here you may change the setting for IP addresss, subnet mask,
DHCP, etc.
IP Address
Shows the IP address of the router.
Subnet Mask
The subnet mask of the router.
Default Gate-
way
Shows the default gateway IP address.
DHCP
Disabled: Select to disable this Router to distribute IP addresses.
Client: Select to enable the router works as a client.
Server: Select to enable this Router to distribute IP Addresses (DHCP
Server). And the following field will be activated for you to enter the
starting IP Address.
DHCP Client
Range
The starting address of this local IP network address pool. The pool is
a piece of continuous IP address segment. Keep the default value
192.168.1.1 should work for most cases.
• Maximum: 253. Default value 253 should work for
most cases.
Note: If “Continuous IP address poll starts” is set at 192.168.1.1 and
the “Number of IP address in pool” is 253, the device will distribute IP
addresses from 192.168.1.1 to 192.168.1.253 to all the computers in
the network that request IP addresses from DHCP server (Router)
Show Client
Click to show Active DHCP Client Table.