User Manual

Wireless Station Configuration

This section applies to all Wireless stations wishing to use the Wireless Router's Access Point,

regardless of the operating system which is used on the client.

To use the Wireless Access Point in the Wireless Router, each Wireless Station must have

compatible settings, as follows:

Mode

The mode must be set to Infrastructure.

SSID (ESSID)

This must match the value used on the Wireless Router. The default

value is Untitled

Note! The SSID is case sensitive.

WEP By default, WEP on the Wireless Router is disabled.

• If WEP remains disabled on the Wireless Router, all stations must

have WEP disabled.

• If WEP is enabled on the Wireless Router, each station must use the

same settings as the Wireless Router.

WPA

WPA2 (AES)

WPA2 Mixed

WPA (TKIP/AES)/ WPA2 (AES)/ WPA2 Mixed: If one of these

securities is enabled on the Wireless Router, each station must use the

same settings as the Wireless Router. If there is no security is enabled on

the Wireless Router, the security of each station should be disabled as

well.

Note: By default, the Wireless Router will allow both 802.11b,802.11g and

802.11n connections.