User Manual

59
Wireless LAN Configuration
To allow Wireless Stations to use the Access Point, the Wireless Stations and the Access Point
must use the same settings, as follows:
Mode
On client Wireless Stations, the mode must be set to "Infrastructure".
(The Access Point is always in "Infrastructure" mode.)
SSID (ESSID)
Wireless Stations should use the same SSID (ESSID) as the Access
Point they wish to connect to, but the SSID can not set to be null (blank).
WEP
The Wireless Stations and the Access Point must use the same settings
for WEP (64 Bit, 128 Bit).
WEP Key: If WEP is enabled, the Key must be the same on the Wire-
less Stations and the Access Point.
WEP Authentication: If WEP is enabled, all Wireless Stations must
use the same setting as the Access Point (either "Open System" or
"Shared Key").
WPA
WPA2 (AES)
WPA2 Mixed
WPA (TKIP/AES)/ WPA2 (AES)/ WPA2 Mixed: If one of these securi-
ties is enabled on the Wireless Router, each station must use the same
settings as the Wireless Router. If there is no security is enabled on the
Wireless Router, the security of each station should be disabled as well.