User's Manual

Chapter 3: Configuration
25
WPA2 Cipher Suite: here supported AES only.
Pre-Shared Key Format: There are two formats for choice to set the
Pre-shared key, Passphrase and Hex (64 characters). If Hex is
selected, users will have to enter a 64 characters string. For easier
configuration, the Passphrase (at least 8 characters) format is
recommended.
Pre-Shared Key : Pre-Shared Key serves as a password. Users may
key in 8 to 63 characters string if you selected passphrase. Pre-shared
key format to set the passwords or leave it blank, in which the 802.1x
Authentication will be activated. Make sure the same password is used
on client's end.
WPA-Mixed
Authentication Mode: Personal (Pre-Shared Key).
WPA Cipher Suite: here supported AES only.
WPA2 Cipher Suite: here supported AES only.
Pre-Shared Key Format: There are two formats for choice to set the
Pre-shared key, Passphrase and Hex (64 characters). If Hex is
selected, users will have to enter a 64 characters string. For easier
configuration, the Passphrase (at least 8 characters) format is
recommended.
Pre-Shared Key : Pre-Shared Key serves as a password. Users may
key in 8 to 63 characters string if you selected passphrase. Pre-shared
key format to set the passwords or leave it blank, in which the 802.1x
Authentication will be activated. Make sure the same password is used
on client's end.
WDS Setup
Wireless Distribution System uses wireless media to communicate with other APs, like the Ethernet
does. To do this, you must set these APs in the same channel and set MAC address of other APs which
you want to communicate with in the table and then enable the WDS. If you would like to setup this
WDS function, please go to Wireless > General Setup, and then select the Mode into WDS mode.
Then go to the WDS Setup page to enable the WDS.