User's Manual

Chapter 3: Configuration

To use WDS function:

1. The APs must support WDS function.

2. (To set WDS must use the same wireless products (the same model will be better); due to different

wireless products might support different WDS settings. Thus, it is suggested that to use the same

wireless products that support WDS function.)

3. To set the same SSID and channel on the APs.

4. To set the same Wireless MAC address(BSSID) on the APs.

5. To set same security (WEP or WPA) on the APs.

If the users would like to set up the WDS function, please go to Wireless> General Setup page to set

up the mode into WDS or AP+ WDS (Repeater) mode. The APs that should use the same SSID and

Channel, then go back to Wireless > WDS Setup page to enter Wireless MAC

(BSSID) of each other

to make the WDS connection.

Step 1: Setup the same SSID and Channel on wireless APs.