User's Manual

Abocom Systems, Inc. .
User Manual
Revision 1.0 • June 27, 2011 - 4 -
2. Installation Guide
2.1. Hardware Installation
There are two ways to install the Adapter:
1. Plug the Adapter directly to the USB port on your computer.
2. Connect the Adapter and your computer through the USB cable attached in package.

Note:
The promoted Found New Hardware Wizard screen will pop up when the adapter is
installed correctly. Click Cancel.
2.2. Software Installation
2.2.1 For Windows XP
The Setup steps for Windows 2000 and XP are similar with each other. This user guide
takes Windows XP for example.
1. Insert the Resource CD into your CD-ROM drive. To continue, double-click My
Computer, and then double-click the CD/DVD drive where the installation CD was
placed. Open 802.11/B/G/N USB DONGLE folder, and double-click Setup.exe.
2. Click Next to continue.
3. After that, you should choose a Setup type. It is recommended that you select Install
Client Utilities and Driver. Select Install Driver Only to install driver only, select
Make Driver Installation Diskette(s) to make the diskette(s) as the installation driver.
Click Next to continue.
4. Click Browse… to change the destination location for the software, then click Next in
the screen below.
5. After that, select the program folder, you should create a new folder name or select
one from the Existing Folders list. It is recommended that you keep the default
setting. Click Next to continue the installation.
6. Choose configuration tool, if you are not sure, please leave it default. Then click Next
to continue.
7. Click OK to continue the Installation. Wait a while for the setup.

Note:
For Windows XP, the Setup Wizard will notify you of how to proceed with the installation
during these steps. Our drivers have been tested thoroughly, and are able to work with the
operating system. Click Continue Anyway to continue the Installation.