User's Manual

-
21 -
includes WEP, TKIP, AES, and Not Use.
Signal
Shows the receiving signal strength of specified network.
Rescan
Click to refresh the AP list.
Add to Profile
Select an item on the list and then click to add it into the
profile list.
Connect
Select an item on the list and then click to make a
connection.
Connected AP information
When you double click on the intended AP, you can see AP's detail information
that divides into three parts. They are General, WPS, CCX information. The
introduction is as following:
General
General information contain AP's SSID, MAC address,
Authentication Type, Encryption Type, Channel, Network
Type, Beacon Interval, Signal Strength and Supported
Rates.
Close: Click this button to exit the information screen.