User's Manual

-
38 -
authentication mode, the selections of encryption
type are Not Use and WEP. For WPA-PSK,
WPA2-PSK, and WPA-PSK/ WPA2-PSK
authentication mode, the encryption type supports
both TKIP and AES.
WPA Pre-shared Key: This is the shared secret
between AP and STA. For WPA-PSK and
WPA2-PSK and WPA-PSK/ WPA2-PSK
authentication mode, this field must be filled with
character longer than 8 and less than 32 lengths.
Group Re-key Interval: Only valid when using
WPA-PSK, WPA2-PSK, and WPA-PSK/
WPA2-PSK authentication mode to renew key. User
can set to change by seconds or packets. Default is
600 seconds.
WEP Key: Only valid when using WEP encryption
algorithm. The key must match with the AP’s key.
There are several formats to enter the keys.
• Hexadecimal (64bits): 10 Hex characters.
• Hexadecimal (128bits): 26 Hex characters.
• ASCII (64bits): 5 ASCII characters.
• ASCII (128bits): 13 ASCII characters.
Show Password: Check this box to show the
password you entered.
Beacon (ms)
The time between two beacons. The system default
is 100 ms.
TX Power
Manually force the AP transmits power from the
pull down list 100%, 75%, 50%, 25% and lowest.
The system default is 100%.
Idle time(60-3600)(s)
It represents that the AP will idle after few seconds.
The time must be set between 60~3600 seconds.