User's Manual

Receive
Shows the current Link Speed and Throughput of receive rate.
Link Speed
Shows the current transmitting rate and receiving rate.
Throughput
Shows the transmitting and receiving speed of data.
Advanced
This Advanced page provides advanced and detailed settings for your wireless network.
The availability of some specific channels and/or operational frequency bands are country dependent
and are firmware programmed at the factory to match the intended destination. The firmware setting is
not accessible by the end user.
Advanced Tab
Wireless mode
Here supports 2.4G (included 802.11b/g/n) wireless mode.
Enable TX Burst
Check to enable this function. This function enables the adapter to deliver
better throughput during a period of time, it only takes effect when connecting
with the AP that supports this function.
Enable TCP
Window Size
Check to increase the transmission quality. The large TCP window size the
better performance.
Fast Roaming at
dBm
Check to set the roaming interval, fast to roaming, setup by transmits power.
Default setting is -70dBm.
Show
Authentication
Status Dialog
When you connect AP with authentication, choose whether show
"Authentication Status Dialog" or not. Authentication Status Dialog displays
the process about 802.1x authentications.
Enable CCX
(Cisco Compatible
extensions)
Check to enable the CCX function.
• Turn on CCKM.
• Enable Radio Measurements: Check to enable the Radio measurement
function.
• Non-Serving Measurements limit: User can set channel measurement every
0~2000 milliseconds. Default is set to 250 milliseconds.
Apply
Click to apply above settings.
-
20 -