User's Manual

If you select the AP that listed in the WPS Profile List field, you can click the
Detail button to see more AP information.
SSID: Shows the connected AP network name.
BSSID: The MAC address of the connected AP. Fixed and cannot be changed.
Authentication Type: The authentication type support Open, WPA-PSK and
WPA2-PSK.
Encryption Type: For Open authentication mode, the selection of encryption
type are NONE and WEP. For WPA-PSK and WPA2-PSK authentication
mode, the encryption type supports both TKIP and AES.
Key Length: Only valid when using Open authentication mode and WEP
encryption. There are key lengths 5, 10, 13 and 26.
Key Index: Only valid when using Open authentication mode and WEP
encryption. There are 1~4 key index.
Key Material: The key material can be used to ensure the security of your
wireless network. Fill in the appropriate value or phrase in Key Material field.
Show Password: Check this box to show the passwords that have been entered.
OK: Click to save and apply the new settings.
Cancel: Click to leave and discard the settings.
Connect
Command to connect to the selected network inside credentials. The active
selected credential is as like as the active selected Profile.
Rotate
Command to rotate to connect to the next network inside credentials.
Disconnect
Stop WPS action and disconnect this active link. And then select the last profile
at the Profile Page. If there is an empty profile page, the driver will select any
non-security AP.
Export Profile
Export all credentials to Profile.
Delete
Delete an existing credential. And then select the next credential if exist. If there
is an empty credential, the driver will select any non-security AP.
-
24 -