User's Manual

Config
SSID
AP name of user type. User also can click Use Mac Address button to
display it.
Channel
Manually force the AP using the channel. The system default is CH 1.
Wireless mode
Here supports 2.4G (included 802.11b/g/n) wireless mode.
Use Mac Address
Click this button to replace SSID by MAC address.
Security Setting
Authentication mode and encryption algorithm used within the AP. The
system default is no authentication and encryption.
Authentication Type: There are several types of authentication modes
including Open, Shared, WPA-PSK, WPA2-PSK, and WPA-PSK/
WPA2-PSK.
Encryption Type: For Open and Shared authentication mode, the
selections of encryption type are Not Use and WEP. For WPA-PSK,
WPA2-PSK, and WPA-PSK/ WPA2-PSK authentication mode, the
encryption type supports both TKIP and AES.
WPA Pre-shared Key: This is the shared secret between AP and STA. For
WPA-PSK and WPA2-PSK and WPA-PSK/ WPA2-PSK authentication
mode, this field must be filled with character longer than 8 and less than 64
lengths.
Group Re-key Interval: Only valid when using WPA-PSK, WPA2-PSK,
and WPA-PSK/ WPA2-PSK authentication mode to renew key. User can
set to change by seconds or packets. Default is 600 seconds.
WEP Key: Only valid when using WEP encryption algorithm. The key
must match with the AP’s key. There are two formats to enter the keys.
• Hexadecimal (128bits): 26 Hex characters.
• ASCII (128bits): 13 ASCII characters.
Show Password: Check this box to show the password you entered.
Beacon (ms)
The time between two beacons. The system default is 100 ms.
TX Power
Manually force the AP transmits power from the pull down list 100%, 75%,
50%, 25% and lowest. The system default is 100%.
-
27 -