User's Manual

2347. Should you encounter inconsistent data flow, only minor
modifications of this value are recommended.
Fragment Threshold: User can adjust the Fragment threshold number by
sliding the bar or key in the value directly. The default value is 2346. The
mechanism of Fragmentation Threshold is used to improve the efficiency
when high traffic flows along in the wireless network. If your Wireless
LAN Adapter often transmits large files in wireless network, you can enter
new Fragment Threshold value to split the packet. The value can be set
from 256 to 2346.
Authentication and Encryption tab:
Authentication Type: There are six type of authentication modes including
Open, Shared, WPA, WPA-PSK, WPA2 and WPA2-PSK.
• Open: If your access point/ wireless router is using "Open”
authentication, then the wireless adapter will need to be set to the same
authentication type.
• Shared: Shared key is when both the sender and the recipient share a
secret key.
• WPA/ WPA-PSK/ WPA2/ WPA2-PSK: WPA-PSK offers two
encryption methods, TKIP and AES. Select the type of algorithm, TKIP
or AES and then enter a WPA Shared Key of 8-63 characters in the
WPA Pre-shared Key field.
Encryption Type: For Open and Shared authentication mode, the
selection of encryption type are None and WEP. For WPA, WPA2,
WPA-PSK and WPA2-PSK authentication mode, the encryption type
supports both TKIP and AES.
WPA Pre-shared Key: This blank is the shared secret between AP and
STA. For WPA-PSK and WPA2-PSK authentication mode, this field must
be filled with character longer than 8 and less than 64 lengths.
WEP Key: Only valid when using WEP encryption algorithm. The key
must match with the AP’s key. There are several formats to enter the keys.
• Hexadecimal (128bits): 26 Hex characters (0~9, a~f).
• ASCII (128bits): 13 ASCII characters.
-
36 -