User Manual

- 5 -
HARDWARE INSTALLATION
1. Bend the WLAN module securing plate 90 angles.
2. Slide in the module, and make sure it is aligning to the white strip.
3. The WLAN module insert the white strip through the securing plate hole to
secure them both.
4. Pull the strip with full strength to make sure it’s tight.
5. Repeat steps of 3,4 to secure the 2
nd
strip.
6. Loose the Antenna lock off.
7. Insert the Antenna into the chassis.
8. Pass the Antenna lock through the wire.
9. Secure the Antenna, and bend the Antenna up to 90 angles.
10. Aiming the Antenna cable to the module.
Attach the Antenna cable onto the connector of WLAN module.
11. Connect the USB connector to USB header.
Verify
To verify if the device exists in your computer and is enabled, go to Start à
Settings à Control Panel à System (à Hardware) à Device Manager.
Expand the Network Adapters category. If the 802.11b+g USB Wireless LAN
Adapter is listed here, it means that your device is properly installed and enabled.