User Manual

This device is intended only for OEM integrators under the
following conditions:
1) The antenna must be installed such that 20 cm is
maintained between the antenna and users. For laptop
installations, the antenna must be installed to ensure that
the proper spacing is maintained in the event the users
places the device in their lap during use (i.e. positioning
of antennas must be placed in the upper portion of the
LCD panel only to ensure 20 cm will be maintained if
the user places the device in their lap for use) and
2) The transmitter module may not be co-located with any other
transmitter or antenna.
As long as the 2 conditions above are met, further
transmitter testing will not be required. However, the
OEM integrator is still responsible for testing their
end-product for any additional compliance requirements
required with this module installed (for example, digital
device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions
can not be met (for example certain laptop configurations
or co-location with another transmitter), then the FCC
authorization is no longer considered valid and the FCC ID
can not be used on the final product. In these
circumstances, the OEM integrator will be responsible for
re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization.
End Product Labeling