User's Manual

- 63 -
between AP and STA. For WPA-PSK and
WPA2-PSK and WPA-PSK/ WPA2-PSK
authentication mode, this field must be filled with
character longer than 8 and less than 32 lengths.
Group Rekey Interval: Only valid when using
WPA-PSK, WPA2-PSK, and WPA-PSK/
WPA2-PSK authentication mode to renew key. User
can set to change by seconds or packets. Default is
10 seconds.
WEP Key: Only valid when using WEP encryption
algorithm. The key must match with the AP’s key.
There are several formats to enter the keys.
• Hexadecimal (64bits): 10 Hex characters.
• Hexadecimal (128bits): 26 Hex characters.
• ASCII (64bits): 5 ASCII characters.
• ASCII (128bits): 13 ASCII characters.
Show Password: Check this box to show the
password you entered.
Beacon (ms)
The time between two beacons. The system default
is 100 ms.
TX Power
Manually force the AP transmits power from the
pull down list 100%, 75%, 50%, 25% and Lowest.
The system default is 100%.
Idle time(60-3600)(s)
It represents that the AP will idle after few seconds.
The time must be set between 60~3600 seconds.
Default value of idle time is 300 seconds.
No forwarding
among wireless
clients
No beacon among wireless client, clients can share
information each other. The system default is no
forwarding.
Hide SSID
Do not display AP name. System default no hide.
Default
Use the system default value.
Apply
Click to apply the above settings.