Installation Guide

Layout the entire project on a flat
surface before installing the tiles to
be sure you have enough tiles and
your design is correct. Using a chalk
line or level, create at least one
vertical and one horizontal reference
lines to guide tile placement.lines to guide tile placement.
Use Dremel/chop saw/band saw if
need to cut through tiles.
Use a utility knife make a pass with
force and snap off follow the cutting
line.
Remove the film backing from both
sides of the tile. Lightly place the
tile onto the wall using your reference
lines. Do not apply pressure to the tile
until you are sure of your placement.
Use a laminate roller to make the
tiles stick firmly to the wall.
Use a utility knife to cut along the
seam line between each piece.
Clean the wall with water and a
powerful grease-remover such
as TSP. Allow enough time for
the surface to dry completely.
ReinforcePeel and StickMeasure The Area
Cut The Tile ⅢCut The Tile ⅡCut The TileⅠClean The Wall
Peel & Stick PVC Tile Installation Guide
Tips:
① The cutting area should be smaller than
the coverage area of the outlet so that the
gap will not be exposed after installation.
② You can use peel and stick trim to
decorate the edges of the tiles.
③ ③ The tiles should be installed at least 16
inches from the stove.
③ Please feel free to contact our customer
service for any questions, we are stand
behind our products.
1 3
2 4 5
1. Clean the wall
2. Measure the area
3. Cut the tile
4. Peel and stick
5. Reinforce