Instructions / Assembly

GBM
GBM MANUFACTURING
INCORPORATED
Unleash Your Mind
California Head Office
1188 S Airport Way
Stockton, CA 95205
Texas Distribution Center
3835 Gulfway Drive
Port Arthur, TX 77642
Florida Distribution Center
924 Lane Avenue North
Jacksonville, FL 32254
1 [phone] Toll Free
1 [phone] Fax
www.GBMglass.com
GBM
GBM
It is noteworthy that the risk of scratches is present when sanded grout is used (regular
grout and epoxy grout) particularly on tile with shiny surfaces. Likewise, avoid abrasive
products for cleaning.
EXTREMELY HOT OR HEATED ENVIRONMENTS
GBM glass tiles can be used in heated areas such as steam rooms, showers, saunas or
hot pools. The proper installation of GBM glass tiles is critical to avoid stress on the glass.
CUTTING GLASS TILES
The easiest, fastest and best way to cut our glass tiles is with a simple glass-scoring tool
and a straight edge. IMPORTANT! All cut edges on GBM glass tiles need to be
embedded completely with the setting material. To cut, score the glass lightly on the
front or unpainted side of the tile along the desired cut line and snap along the line. To
snap the tile, place the tip of a tapered hardwood dowel, similar to the size of a pencil,
directly under the edge of the scored line and place even pressure on both sides.
Carbide wheel glass-scoring tools are available at nearly all hardware stores. A very
useful and important tool for all glass tile installations is a pair of GLASS RUN PLIERS. Using
glass run pliers allows the installer to easily cut and trim G.B.M. glass tiles. Cuts as thin as
3/8” or smaller are possible.
Once the tile surface is scored, the score line is aligned with a white stripe on the top of
the pliers jaw. Slight pressure applied to the pliers will snap the glass. When score
cutting, be sure to use the Glass Run Pliers to affect the initial cutting of the glass. Then,
while holding the tile face up, separate the tile with a downward motion allowing the
cut edge to sever the tile membrane.
GBM. glass tiles can also be cut with a wet saw. If using a wet saw, be sure to use a
glass compatible diamond blade in good condition. A blade for cutting glass has
smaller diamonds than a tile blade and has a continuous rim. Most blades designed
for ceramic tiles are coarse and will chip the glass. It is very important when cutting
glass with a wet saw to have adequate water flow and to cut slowly. It is best to
practice making a few cuts with regular 1/4” window glass before proceeding to cut
the tile. A lapidary blade will also make a very clean cut on glass.
When cutting glass tile on a wet saw, it is required to cut the tile face down. This will
prevent chipping of the colored areas of the tile. A piece of electrical tape, masking
tape or duct tape laid along the line of the cut on the tile face will greatly reduce
chipping along the edge. A light piece of cardboard or building paper on the saw bed
will protect the surface of the glass from scratches.
All edges must be sealed with an epoxy grout system to ensure complete protection to
the tiles.
Edges of the cut tile can be chamfered with a diamond hand pad. Hand pads and
related glass tile cutting tools are available through 3M Corporation as well as a variety
of other glass tool distributors found on the Internet. Silicon carbide sanding belts may
be used if the belt is dressed with a light coat of silicone spray.