Instructions / Assembly

INSIDE THE BOX: GLASS SHELF AND HARDWARE (4 MOLLYS, 6 SCREWS, and 2 BRACKETS)

RECOMMENDED TOOLS

DRILLL TAPE MESSURE LEVEL HAMMER PENCIL

1) Remove the shelf and hardware from the packaging.

2) Place the shelf up against the wall where you wish to install it then mark on the wall with a pencil a fist length from the edge in.

3) Remove the shelf and use your drill to drill holes where you marked with a pencil.

4) Insert the included mollies one at a time into the holes you drilled using a hammer.

5) Take your brackets apart. Your brackets come apart, you will have an upper bracket and a bottom bracket. The small bracket is your upper

bracket.

6) Take the upper bracket (small one) and place the bottom hole over the molly and insert the screw through.

7) Insert the bottom part of the bracket and tighten the screw at the bottom being sure to leave some space in between for your shelf.

8) Insert your shelf into the space and tighten the bottom screw making sure that the brackets are tightly gripping the shelf.

CONGRATULATIONS!

Installation of your new shelf is complete! Enjoy!

PAGE 1
INSIDE THE BOX: GLASS SHELF AND HARDWARE (4 MOLLYS, 6 SCREWS, and 2 BRACKETS) RECOMMENDED TOOLS DRILLL TAPE MESSURE LEVEL HAMMER PENCIL 1) Remove the shelf and hardware from the packaging. 2) Place the shelf up against the wall where you wish to install it then mark on the wall with a pencil a fist length from the edge in. 3) Remove the shelf and use your drill to drill holes where you marked with a pencil. 4) Insert the included mollies one at a time into the holes you drilled using a hammer.