User Manual

Use Antenna Extension
Note:
When wireless signal is weaker, users can take off the original antenna and
subtitute antenna extension cord. Drill a hole on the wall to let the extension
cord go through and simply put it where wireless signal is strong.
Step 2: Click + to select the channel with the stronger signal value to
connect to the NVR, and the weaker signal value to connect to the channel
with stronger signal value. As shown in the picture, the signal values of CH1
and CH2 are strong. We can connect CH3 and CH4 behind CH1 and CH2.
Step 3: Click “Apply” to finish the cascading connection. Click “Refresh” to
check if it’s set successfully. To cancel selection, click on the seleted chan-
nel, then click “Apply” and “Ok”.
Installation method of antenna extension cord
13
[e-mail]