Instructions

User Manual of Water-Proof Brushless Speed Controller (RTR Version) Page - 1 -
【
DECLARATION】
Thanks for purchasing our electronic speed controller (ESC). The power system for RC model can be very
dangerous, so please read this manual carefully. In that we have no control over the correct use,
installation, application, or maintenance of our products, no liability shall be assumed or accepted for
any damages, losses or costs resulting from the use of the product.
【
FEATURES】
1. Water-proof and dust-proof. The ESC can work under water for a short time.
(Please remove the cooling fan when running car in water, and after running, please make the ESC
clean and then dry it to avoid the oxidation to copper connectors)
2. Specially designed for RC car and truck, with excellent start-up, acceleration and linearity features.
3. Drive sensorless brushless motors.
4. 2 running modes (“Forward with brake” mode, “Forward/Backward with brake” mode).
5. Proportional ABS brake function with 4 steps of maximum brake force adjustment, 8 steps of drag-brake force
adjustment.
6. 4 start modes (“Punch”) from “Soft” to “Very aggressive” to be suitable for dif
ferent chassis, tires and tracks.
7. Multiple protection features: Low voltage cut-off protection for Lipo or NiMH battery / Over-heat protection /
Throttle signal loss protection / Motor blocked protection.
8. Easily programmed with the “SET” button on the ESC.
【
SPECIFICATIONS】
* Note1:
1)
The cooling fan on the WP-10BL50-RTR -
is powered by the built
in BEC, so the 5V fan
is OK and there is no need to consider if the input voltage is high or low.
2)In addition, please detach the fan from the ESC when running the vehicle in water/rain.
【
BEGIN TO USE THE NEW ESC】
1. Connect the ESC, motor, receiver,
battery and servo according to the
following diagram
“ + ” and “ - ” wires of the ESC are
connected with the battery pack, and #A,
#B and #C are connected with the motor
wires. The “SET” button is used for
programming the ESC.
The control cable of the ESC (trio wires
with black, red and white color) is
connected with the throttle channel of the
receiver (Usually CH2).
The #A, #B, #C wires of the ESC can be
connected with the motor wires freely
(without any order). If the motor runs in
the opposite direction, please swap any
two wire connections.
Note: You can use the transmitter to
set the throttle channel to
Waterproof
Sensorless Brushless
Speed Controller
A10 ECO
USER MANUAL
WP-10BL50-RTR
50A/300A
0.0010 ohm
5V
Model
Cur rent
Built -in BEC
On-road: ≥ 8T
Off-road: ≥ 11T
1/10 Onroad / Offroad
6V/3A (Switch Mode)
Battery
On-road: ≥ 11T
Off-road: ≥ 14T
48.5*38*32/90g
Motor
Limit
Cont./ Burst
Resistance
Car Applicable
2S Lipo
6 cells
NiMH
3S Lipo
9 cells
NiMH
3650 size motor
3650 size motor
4-9 cells MiMH or 2-3S Lipo
Rating Voltage of
the stock Cooling
Fan (
*Note 1)
Program Port Multiplexed with cooling fan port
Dimension/ Weight