Instructions

LED lights:

Direction control mode for servo normal steering:

Blue light is always on.

Mixed direction control mode for tank: Red light is always on.

Low voltage warning: Light ﬂashes slowly.

Enter into the Programming mode: Light fast ﬂashing.

Channel 5 and Channel 6:

Channel 5

Press one time CH5 button, indicator LED will stay on

and connected servo will move left to end point

for 38% and hold.

Press second time, LED off and connected servo will

move back to normal.

Channel 6

Press one time CH6 button, indicator LED will stay on

and connected servo will move right to end point for 38%

and hold.

Press second time, LED off and connected servo will move back to normal.

(Both movement are fxed at factory setting and not adjustable)

LED light

MENU SETTING:

Enter programming mode

Before power on transmitter, turn wheel backward to the maximum, at the same time pull the trigger

backward to the maximum.

Hold the position and power on transmitter

Release the wheel and trigger, press 3nd channel button, panel indicator light will go ﬂashing,

programming mode on ready for setting.

1. Turn wheel anticlockwise

to the end and hold

2. Pull trigger to the end and hold

4. Release wheel and

trigger back to normal

3. Power on

5. Press Channel 3 button,

LED light go ﬂashing

After enter programming mode

Channel 1 setting

Step 1. >>Turn the steering wheel clockwise point to the angle need for right steering

Turn the steering wheel anti-clockwise point to the angle need for left steering

Step 2. >>Pull the trigger point to the route need for throttle forward

Push the trigger point to the route need for throttle backward (Brake)

Step 3. >>Only after Step 1 and Step 2, cease for 3 second then press CH3 button for conﬁrm setting and ﬁnish

(indicator light stay on). If route of Channel 3 and Channel 4 need to do setting also, no need to

press CH3 for conﬁrmation, just go to Step 4.

If only Channel 4 need to do setting, then just go to Step 5.

Route setting of Channel 1 and Channel 2 / Channel 3 / Channel 4

Channel 1 route setting Channel 2 route setting Channel 3 button for conﬁrmation