Installation User guide

56
UK
00
Burg=Latched
The output remains activated until the
user or programmer resets the alarm
centre.
01
Burg=Rearm
The output is reset following expiry of
the defined siren duration. It can be
reactivated in the event of a new alarm.
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double “beep” tone and shows Installer Mode.
086 Additional entry delay
To change the behaviour of the entry delay time:
1. On the control unit, enter:
086
2. The LCD display shows: 086:Dual Ply OFF
3. Via the keypad, select from the following items
and press:
0
Dual Ply OFF
An alarm is triggered following expiry of
the entry delay time.
1
Dual Ply ON
An internal alarm is triggered following
expiry of the delay time. The user has
another 30 seconds to enter the user
code and deactivate the alarm centre.
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double “beep” tone and shows Installer Mode.
087 Control unit alarm
To change the properties of the connected control units:
1. On the control unit, enter:
087
2. The LCD display shows: 087:Dual Key OFF
3. Via the keypad, select from the following items
and press:
0
Dual Key OFF
If the function is deactivated, no alarm
can be emitted by the control unit.
1
Dual Key ON
If the function is activated, an alarm can
be emitted by the control unit. To trigger
an alarm, press the following keys:
1 & 3 for panic
4 & 6 for medical emergency
7 & 9 for fire alarm
For further information, see the
operating instructions of this product.
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double “beep” tone and shows Installer Mode.
090 - 097 Test function see 15.4
098 Factory settings
To restore the factory settings:
1. You must be in program mode.
2. On the control unit, enter: 098
3. The LCD display shows: 098: Load Default
4. On the control unit, enter: 1
5. To restore the factory settings, press the following
key:
.
6. To abort, press: .
7. The control unit acknowledges your input with a
double “beep” tone and shows Installer Mode.
099 Exit program mode
To exit program mode:
1. On the control unit, enter:
099
2. The LCD display shows: 099: exit Eng ?