Datasheet

ABUS Security-Center

BW8030

Xevox Duplex MW VdS motion detector

Product highlights:

• PIR and microwave element

• VdS-certified

• Alarm memory and first-sensor recognition

• Detection range: 15 x 15m

• Aperture angle: 90°, ideal for corner mounting

The Xevox Duplex MW VdS motion detector is a motion sensor with

one PIR and one microwave sensor. An alarm is not triggered until

both sensors register movement.

The combination of passive infrared (PIR) and microwave (MW)

ensures very high protection against false alarms. The reason: An

alarm is not triggered until both sensors – which use technically

different detection methods – register movement. Whereas the PIR

sensor reacts to moving heat, the microwave sensor actively

monitors the surroundings for movement (similar to radar). The

transmission frequency is 9.35 GHz.

The best place to install the sensor is in a corner, between 2 and 3

metres above the floor. The intruder’s possible direction of

movement should be at right-angles to the sensor.

The viewing angle of the Xevox Duplex MW VdS motion detector

sensor is 90 degrees, and the detection range – depending on

installation height – up to 15 x 15 metres. You can vary its sensitivity

by means of a jumper. In this way, you can define the number of

pulses that have to be detected before the sensor opens the alarm

relay.

The Xevox Duplex MW VdS motion detector sensor has an alarm

memory. If the alarm centre is disarmed following an alarm, the LED on the sensor that triggered the alarm lights up. Depending on the

configuration, you can also see which sensor first triggered the alarm. Due to its reliability and high quality, the Xevox Duplex MW VdS

motion detector sensor is VdS-certified.

PAGE 1
ABUS Security-Center BW8030 Xevox Duplex MW VdS motion detector The Xevox Duplex MW VdS motion detector is a motion sensor with one PIR and one microwave sensor. An alarm is not triggered until both sensors register movement. The combination of passive infrared (PIR) and microwave (MW) ensures very high protection against false alarms. The reason: An alarm is not triggered until both sensors – which use technically different detection methods – register movement.
PAGE 2
ABUS Security-Center BW8030 Xevox Duplex MW VdS motion detector Technical Data Installation Wall Detection method PIR / MW Detection range (m) 15 x 15 Alarm memory Yes Immune to animals No Power consumption 13 mA Voltage supply 9 -16 V Alarm contact NC, 100 mA, 24 V DC Tamper contact NC, 100 mA, 24 V DC Temperature range -10° to 55 °C VdS G106509 VSÖ GS-N060614/05E © 2012 ABUS Security-Center GmbH & Co. KG, Errors and omissions excepted.