Technical data

69
17.2 Remote control / remote access by telephone
This function enables a user to give commands to the wireless alarm centre from a
remote location using the telephone keypad. The available commands are as follows.
More information can be found in the operating manual. There are two possibilities
here:
Call-out control
When set to Y, the user can control the system remotely when answering a call from
the wireless alarm centre.
When set to N, the user can still use the remote commands for the voice dialler, but
not the remote control options.
Call-in control
When set to Y, the user can call the wireless alarm centre remotely. A user can send
commands using the telephone keypad after identifying themselves to the wireless
alarm centre with an access code.
17.3 Selecting a language
Select the desired language.
17.4 Default settings
Select the corresponding functions from the table.
When “Call-in control” is set to “Y”, the wireless alarm centre does not
answer any incoming calls from the downloader.
Function Input
Deactivate system #0*0
Activate system #0*1
Activate system internally #0*2
Disable sirens #1*0
Reset system #1*1
Query system #3*
Switch ON output nn #9*nn*1
Switch OFF output nn #9*nn*0
Switch output nn #9*nn*
The system loads all default settings (apart from the access codes) and
the log.
The log is write-protected and cannot be deleted by the installer.