Operation Manual

22
English
5.2. Orientation of the camera
Loosen the fixing screw on the camera base plate if necessary. The camera centre section can
now be oriented in three axes. Tighten the fixing screw again when finished.
Tilting
75°
Panning
90°
Rotation
360°
5.3. Power supply
IMPORTANT!
Before starting installation, ensure that the mains voltage and the rated voltage of
the camera are identical.
(1) Video signal (BNC)
(2) Power supply
12 V DC (5.5 x 2.1 mm)
The cameras have a 12 V DC power supply. Ensure correct polarity when connecting. A power supply
unit (round plug, 5.5 mm x 2.1 mm) is provided for the connection.
5.4. Connecting the video cable
In order to transmit the HD-TVI video signal from the camera to an HD-TVI recorder, an RG59 type
coaxial cable with BNC connector (male) must be connected to the connection labelled 'TVI'. The
cable length to the next device must not exceed 500 m (RG6) or 300 m (RG59).
To ensure optimum quality of the HD-TVI signal transmission, it is important that the
cable is neither kinked nor crushed at any point, and that its radius is adequate (min.
bending radius 6 cm).
Damage to the cable or porosity as a result of ageing can have a negative impact on
the quality of the signal or image (e.g. shadowing around the edges).
360°
0~90°
0~75°

