Operating Instructions and Installation Instructions
– 28 – – 29 –
Maintenance and inspection
A smoke detector must always be at least once a year in accordance with DIN 14676
are checked for functionality. A functional test can be triggered by prolonged
activation of the test button with this smoke alarm (5 in Figure 1).
The LED then ashes quickly and it is a conrmation tone.
Cleaning
• Dusty detectors must be cleaned. You can clean dust from the air vents of the
detector using a vacuum cleaner or compressed air. If necessary, you can remove
the dust with a brush.
• When changing the battery, carefully clean the detection chamber with a vacuum
cleaner to remove any dust or dirt.
• You can clean the surface using a cloth slightly dampened in soapy water.
Important
• Do not allow water to penetrate inside the device.
• Do not clean the device in a dishwasher.
• Do not use sharp, pointed, abrasive or corrosive cleaning materials or
hard brushes.
• Do not use chemicals.
• Do not use ammable liquids for cleaning.
Information on the EU directive on waste electrical and electronic
equipment
To protect the environment, do not dispose of the device with domestic refuse at
the end of its service life. It can be disposed of at one of the appropriate collection
points in your country. Please obey your local regulations when disposing of matrial.
Cleaning and disposal
Dispose of the device in accordance with EU directive 2002/96/EC – WEEE
(Waste Electrical and Electronic Equipment). If you have any questions,
please contact the department of your local authority which is
responsible for waste disposal. Used equipment can be disposed of, for
example, by your local or municipal authority, the local waste disposal
company or your dealer.
Information on handling batteries
• Make sure that batteries are kept away from small children. Children may put
batteries in their mouths and swallow them. This can cause serious harm to their
health. If this happens, consult a doctor immediately.
• Do not charge normal batteries, heat them up or throw them into naked ames
(they may explode).
• Change low batteries in good time.
• Always change all the batteries at the same time and use batteries of the same
type.
Important
• Leaky or damaged batteries can cause chemical burns in contact with
the skin. In this case, wear protective gloves. Clean the battery
compartment with a dry cloth.
• Do not charge normal batteries, heat them up or throw them into
naked ames (they may explode).
Cleaning and disposal
GB