Operation Manual

137
The settings can be tested using the “Test” button. Accept the settings by
pressing “OK” or cancel them by pressing “Cancel”.
Alarm sending
Alarm sending: Activates or deactivates the transmission of image data (snapshots) to a HTTP
server.
Alarm: In the event of an alarm, certain reactions can be configured for HTTP transmission
here. A button for configuring the corresponding alarm detector is available for each
entry (if configuration of the detector or trigger is possible).
Effective Period:
Always: The detectors for these alarms are permanently activated.
Schedule: The detectors for these alarms are activated at defined schedules. Press the
“Schedule” button to configure these settings (see also the “Schedule” section).
Accept the settings by pressing “OK” or cancel them by pressing “Cancel”.
6.10 Alarm output
The activation of the digital switch output can be configured here. Activation can be made following an event
or over a schedule (timer).
Alarm output: Activates or deactivates the alarm for a specific output