User Manual

English

3.2 LED status display

Status LED description:

In order to reboot the camera or restore the factory settings press the reset button. Use an appropriate small

tool.

Camera reboot: Press the reset button once and wait until the camera to restart.

Restore factory settings: Press and hold the reset button for approx. 30 seconds until the status LEDs start

flashing. All settings will be reset to factory default.

4. Initial start-up

Direct connection between camera and PC / laptop

1. Make sure to use a crossover network cable

2. Connect the cable with the Ethernet port of the PC / Laptop and the camera

3. Connect the power supply to the camera

4. Configure the IP address of the PC / Laptop to 169.254.0.1

5. Continue with point 4.1 in order to finish the initial installing and build-up a connection to the

camera

Status / LED colour Green Red

System start Off On

Camera turned off Off Off

Network works (heartbeat) 1/s On

Network problem Off On

Firmware update 1/s 0.1/s

Restoring factory settings Off 0.1/s

 Crossed Ethernet cable