Owners Manual

15
PROGRAMMING
AIRCOM T8 T9 T10
QUICK START
Press the MODE button until you are on AUTO mode. This mode works like a thermostat. Then
press the up and down triangle buttons to change the SETTING temperature on the screen. The
PROBE temperature is what the thermal probe is measuring. When the PROBE temperature
exceeds the SETTING temperature, the fans will start running.
ON MODE
In this mode, the fans will run non-stop regardless of
temperature. Pressing the up and down buttons while in this
mode will change the speed of the fan. Whichever speed is
designated in this mode will also be the speed used in AUTO
Mode and the max speed of the fans in SMART Mode.
AUTO MODE
This is the thermostat setting where the fans will start running
when the PROBE temperature reaches or surpasses the
SETTING temperature. The SETTING temperature can be
designated by pressing the up and down buttons while in this
mode. Once the fans start running, the PROBE temperature
would need to fall at least 4° F below the SETTING temp for
the fans to stop running. This variation buffer can be changed
to 2° F, see page 18 for more information.