Owners Manual

18
PROGRAMMING
AIRCOM T8 T9 T10
VARIATION BUFFER
In AUTO mode, a buffer is built in to prevent your fan from turning on and off too quickly due
to small variations in the environment. When the PROBE temperature exceeds your SETTING
temperature, the fan will start running immediately. However, the PROBE temperature will need to
fall below your SETTING temperature by 4° Fahrenheit or 2° Celsius or more, to stop the fans from
running. In SMART mode, the speed of the fan will decrease by one level for every 4° Fahrenheit or
2° Celsius that the PROBE temperature is below the SETTING temperature.
To change this buffer or increment setting to 2° Fahrenheit or 1° Celsius, hold the MODE button
and DOWN button together for three seconds. To change back to 4° Fahrenheit or 2° Celsius, hold
the MODE button and UP button together for three seconds.
CONTROLLER LOCK
Holding the MODE button for three or more seconds will lock the controller. The controller will still
work as programmed. However, pressing any buttons will not have an effect and will cause the
screen lock icon to flash. This option was designed to prevent your controller settings from being
changed by accident. Holding the MODE button again for three or more seconds will unlock the
controller.
CONNECTING MORE FANS
On the backside of the AIRCOM T8, T9, and T10 models, there
are two USB ports. Up to six MULTIFAN or AIRPLATE fans can
be plugged into it to share the same programming. A model
can contain more than one fan. For example, an AIRPLATE S7
contains two fans so only three AIRPLATE S7s are supported.
Before daisy chain one more fan, please make sure the
previous fan speed is set on High speed. Please see page 20
for more information.