Owners Manual

17
PROGRAMMING
AIRCOM T8 T9 T10
ALARM SETTING
In this mode, you can set what temperature the
system’s alarm will trigger by pressing the up
and down triangle buttons. When the PROBE
temperature reaches or exceeds the ALARM
temperature, the alarm will activate. The alarm will
only activate while the controller is in ON, AUTO, or
SMART Mode so please remember to exit ALARM
Mode once the alarm has been set.
When the alarm is triggered, the fan will run at max
speed regardless of mode and will make an audible
beep every three seconds. This will keep occurring
until the temperature drops below the ALARM temp
or if any buttons are pressed.
The alarm can be disabled to not trigger
by pressing the up triangle button until the
temperature is at 140° F, then pressing the up
button once more to show “OF”.
FAHRENHEIT OR CELSIUS
The temperatures displayed can be set to Fahrenheit or Celsius scale by holding the LEAF button
until °F or °C is shown after the digits. All digits displayed will be automatically converted to the
designated scale.
ALARM