Template

1. This product includes plastic tracing stencils which are recommended to be used for accuracy.

2. When printing this PDF, please check printer settings to make sure the print is not being scaled.

3. Please measure the lines on this page with a ruler to check if it has been scaled by the printer.

4. The thicker lines indicate where to cut. The lighter lines display where the mounting plate will cover.

5. Screw holes are approximately 4 to 5 mm diameters in size.

6. If you have any questions or concerns, our contact information can be found on www.acinfinity.com

29.7 cm (14.85 cm shown)

25.7 cm (12.85 cm shown)

13.6 cm

25.7 cm (12.85 cm shown)

15.5 cm

12.5 cm

HALF CUT OUT PIECE

FANS ARE INSERTED INTO THIS HOLE

CUT OUT TEMPLATE

AIRPLATE S7 AND T7

This model’s dimensions exceeds the size of an A4 paper. Only HALF of the total

template is shown below. This template should only be used as a reference.

PAGE 1
CUT OUT TEMPLATE AIRPLATE S7 AND T7 1. This product includes plastic tracing stencils which are recommended to be used for accuracy. 2. When printing this PDF, please check printer settings to make sure the print is not being scaled. 3. Please measure the lines on this page with a ruler to check if it has been scaled by the printer. 4. The thicker lines indicate where to cut. The lighter lines display where the mounting plate will cover. 5. Screw holes are approximately 4 to 5 mm diameters in size. 6.