Owners Manual

T-SERIES CONTROLLER

PROGRAMMING

ALARM SETTING

In this mode, you can set what temperature

the system’s alarm will trigger by pressing

the up and down triangle buttons. When the

PROBE temperature reaches or exceeds

the ALARM temperature, the alarm will

activate. The alarm will only activate while the

controller is in ON, AUTO, or SMART Mode

so please remember to exit ALARM Mode

once the alarm has been set. When the alarm

is triggered, the fan’s will run at max speed

regardless of mode and will make an audible

beep every three seconds. This will keep

occurring until the temperature drops below

the ALARM temp or if any buttons are pressed.

The alarm can be disabled by pressing the

triangle button until the ALARM temp says

" OFF"

FAHRENHEIT OR CELSIUS

The temperatures displayed can be set to Fahrenheit or Celsius scale by holding

the LEAF button until °F or °C is shown after the digits. All digits displayed will be

automatically converted to the designated scale. (For Controller 8, hold the

ZONE CHANGE button instead.)

ALARM

SETTING

PROBE