Installation Guide

ASTT30P - WIRING INSTRUCTIONS
DO YOU STILL HAVE QUESTIONS?
Only unscrew the terminals a very lile bit. The washers have two straight sides and two
rounded sides. The straight sides need to fit into the terminal brackets. If you unscrew them
too far, they can be tricky to get back into place. Only unscrew them enough to fit the 30A
terminals in.
First install the white wire, making sure to bend the terminal downwards. Also note that it
should be threaded in behind and through the top of the white screw. Next install the black
wire, again making sure to bend the terminal downwards. Also note that it should be
threaded in behind and through the top the black screw. The terminal for the green wire
needs to bend down, otherwise the casing won’t close.
The reason for this type of installaon is to prevent the off chance of electrical arcing. If the
wires are all going upwards and are close, there is a small potenal for electrical arcing.
This plug works best with ST and SO 10/3 cable. The O ring (strain relief) can stay in its
original layout. If it is a lile difficult to get the cable through this ring, you can warm it up
a lile bit with a hair dryer or add non-flammable lubricant.
Also, be sure to have the handle installed so it lines up behind the tab on the top of the
plug. If it goes in front of that tab, it becomes useless.
Email, call or text our Sales Engineer.
Direct: [phone]
Text: [phone]
[e-mail]
www.ACWORKS.com
ASTT30P - WIRING INSTRUCTIONS
DO YOU STILL HAVE QUESTIONS?
Only unscrew the terminals a very lile bit. The washers have two straight sides and two
rounded sides. The straight sides need to fit into the terminal brackets. If you unscrew them
too far, they can be tricky to get back into place. Only unscrew them enough to fit the 30A
terminals in.
First install the white wire, making sure to bend the terminal downwards. Also note that it
should be threaded in behind and through the top of white screw. Next install the black
wire, again making sure to bend the terminal downwards. Also note that it should be
threaded in behind and through the top the black screw. The terminal for the green wire
needs to bend down, otherwise the casing won’t close.
The reason for this type of installaon is to prevent the off chance of electrical arcing. If the
wires are all going upwards and are close, there is a small potenal for electrical arcing.
This plug works best with ST and SO 10/3 cable. The O ring (strain relief) can stay in its
original layout. If it is a lile difficult to get the cable through this ring, you can warm it up
a lile bit with a hair dryer or add non-flammable lubricant.
Also, be sure to have the handle installed so it lines up behind the tab on the top of the
plug. If it goes in front of that tab, it becomes useless.
Email, call or text our Sales Engineer.
Direct: [phone]
Text: [phone]
[e-mail]
www.ACWORKS.com
GN
BK WT
GN
BK WT
GN
BK WT
GN
BK WT