Installation Guide

ASTT30R - WIRING INSTRUCTIONS
DO YOU STILL HAVE QUESTIONS?
Start by unscrewing each terminal. For this assembly, the use of Y-terminals is not neces-
sary. The terminals inside this connector work best with stripped wire and are far enough
away from eachother to prevent any possibility of electrical arcing.
First, install the black and white wires into their respecve terminals, making sure they are
secured ghtly. The green wire needs to be able to come slightly over the black wire at an
angle. If the angle is too harsh, the copper wire could potenally break apart. So be sure to
have the green wire come in as direct as possible. Then secure it ghtly.
This connector works best with ST and SO 10/3 cable. The O ring (strain relief) can stay in
its original layout. If it is a lile difficult to get the cable through this ring, you can warm it
up a lile bit with a hair dryer or add non-flammable lubricant.
Also, be sure to have the handle installed so it lines up behind the tab on the top of the
plug. If it goes in front of that tab, it becomes useless.
Email, call or text our Sales Engineer.
Direct: [phone]
Text: [phone]
[e-mail]
www.ACWORKS.com
ASTT30R - WIRING INSTRUCTIONS
DO YOU STILL HAVE QUESTIONS?
Start by unscrewing each terminal. For this assembly, the use of Y-terminals is not neces-
sary. The terminals inside this connector work best with stripped wire and are far enough
away from eachother to prevent any possibility of electrical arcing.
First, install the black and white wires into their respecve terminals, making sure they are
secured ghtly. The green wire needs to be able to come slightly over the black wire at an
angle. If the angle is too harsh, the copper wire could potenally break apart. So be sure to
have the green wire come in as direct as possible. Then secure it ghtly.
This connector works best with ST and SO 10/3 cable. The O ring (strain relief) can stay in
its original layout. If it is a lile difficult to get the cable through this ring, you can warm it
up a lile bit with a hair dryer or add non-flammable lubricant.
Also, be sure to have the handle installed so it lines up behind the tab on the top of the
plug. If it goes in front of that tab, it becomes useless.
Email, call or text our Sales Engineer.
Direct: [phone]
Text: [phone]
[e-mail]
www.ACWORKS.com
GN
BK WT
BK WT
BK WT
GN
GN
GN
BK WT