Body Repair Manual

Areas to be Covered by Anti-rust Agents (cont'd)
Rust-preventive Treatments
Front Wheelhouse
• Spray agent on the wheelhouse, front fender stay,
upper member and damper bracket as shown.
• Undercoat the wheelhouse where anti-rust agent or
undercoat has not yet been applied.
NOTE:
• Coat the wheelhouse extension, particularly the upper
face.
• Undercoat the inner fender mounting area of the
wheelhouse and upper face of the inner fender
Nozzles used: A and C
Side Sill, Inside
• Remove the front and rear grommets and side sill panel
to spray agent.
• Insert the nozzle all the way through the grommet holes
and spray.
Move the nozzle right and left, and up and down while
pulling it back out of the grommet hole.
NOTE: Spray agent until it drips from the drain hole.
Nozzles used: A and B
Rear Wheelhouse
• Coat the gaps between the inner and outer
wheelhouses, including the damper base.
• Apply agent to the edge of the rear side frame, side sill
and rear floor.
• Undercoat the wheelhouse where undercoat or
anti-rust agent has not yet been applied.
Nozzles used: B and C
Under-Floor Member/Floor Frame, Inside
• To spray agent to the inside of the under floor member,
insert the nozzle in the holes in the members.
• Also coat the under-floor, side sill, and front and rear
wheelhouses at the ends.
Nozzle used: A
Main Menu
Table of Contents