Body Repair Manual
Make 5 mm (0.2 in) holes in the MIG weld holes with
the outrigger or front side extension, and weld the
front side frame, floor frame and inside sill with a MIG
welder.
2.5TL:
6 point of MIG welding the bending angle of a flange.
Welding pitch=30 mm (1.2 in)
3.2TL:
8. Apply the sealer (see section 5).
Apply sealer to the mating surface of the lower dash-
board and front floor.
9. Apply the paint.
See Paint Repair section.
• Ventilate when spraying paint. Most paint
contains substances that are harmful if inhaled
or swallowed. Read the paint label before
opening the paint container.
• Avoid contact with skin. Wear an approved
respirator, gloves, eye protection and appropriate
clothing when painting.
• Paint is flammable. Store it in a safe place, and
keep it away from sparks, flames or cigarettes.
10. Apply the undercoat.
Undercoat the front floor, etc, and apply anti-rust agent
to the inside of the front side outrigger and side sill (see
section 7).
Main Menu
Table of Contents