Body Repair Manual
Front Fender, Underside
Apply anti-rust agent to the end of the fender, wheelhouse,
and side sill installation.
NOTE:
• Apply a coat of agent to the front door side, wheel arch
end.
• If the fender is to be removed, care take to avoid damaging
the paint finish. Apply agent to the entire surface of the
back of the fender.
• Apply agent to the front fender filling pillar.
Nozzles used: B and C
Outside Panel (Front Pillar and Center Pillar), Inside
• Remove the door harness grommet and insert the nozzle
facing down.
NOTE: Make sure that the nozzle is not interfering with the
door hinge bracket. Spray thoroughly.
• Coat the door checker bracket.
Nozzles used: A and B
Front Pillar
Wheelhouse Upper Member, Inside
• Remove the front fender.
• Remove the air scoop grille in the dashboard upper and
coat the inside of the wheelhouse upper member with
anti-rust agent.
Nozzles used: A and B
Center Pillar
Main Menu
Table of Contents