Body Repair Manual
<Rear>
<Front>
Doors, Inside
• Apply agent to the joint between the door stiffener and
door skin through the water drain hole at the bottom of
the door.
• If necessary, remove the door side molding and weather-
strip, then spray the agent through the hole.
NOTE:
When
a
suction
type spray
gun is
used, remove
the
door trim panel.
Nozzles used: A and B
Rear Side Outer Panel, Inside
• Remove the door lock striker, taillight and grommets, then
spray agent through the hole.
• To apply agent to the inside of the rear wheelhouse,
remove rear trim panel and trunk side trim panel.
NOTE: Make sure that all the surfaces are coated with anti-
rust agent since the areas to be covered are relatively
extensive.
Nozzle used: A
Areas to be Covered by Anti-rust Agents (cont'd)
Rust-preventive Treatments
Main Menu
Table of Contents