Installation guide

Access Control by Example Table of Contents | en 3
Bosch Security Systems Introductory Guide | 1.0 | 2009.10
Table of Contents
1 Introduction 4
1.1 The example 4
2 Materials Planning 6
2.1 Planning the doors 6
2.2 Low tier: Electrical components 6
2.2.1 Card reader technologies 7
2.2.2 Credentials technology 7
2.2.3 Wiring for non-reader components 8
2.3 Middle tier: Access Controllers 8
2.4 High tier: Hosting the software for the final system 9
3 Installation with RS-485, AMC and Access PE 10
3.1 Mounting the access controller and associated hardware 10
3.2 Installing the wiring 10
3.2.1 RS-485 bus topology for readers 10
3.2.2 RS-485 star topology for all other components 10
3.3 Mounting the peripheral components 10
3.4 Connecting the peripheral components to the wiring 11
3.4.1 Protective diodes 11
3.4.2 Shielding data cables and avoiding ground loops 12
3.5 Connecting the AMC2 (Access Modular Controller) 13
3.5.1 Preparatory steps on PBC-60 power supply, AMC2 and computer 13
3.5.2 Connecting the peripheral components to the AMC2 14
3.5.3 Setting up the connection between AMC2 and the software 17
4 Installation with Wiegand and Access Easy Controller (AEC) 19
4.1 Mounting the access controller 19
4.2 Installing the wiring 19
4.2.1 Wiegand star topology for readers 19
4.3 Mounting the peripheral components 19
4.4 Connecting the peripheral components to the wiring 20
4.4.1 Protective diodes 20
4.4.2 Shielding data cables and avoiding ground loops 21
4.5 Connecting the AEC (Access Easy Controller) 22
4.5.1 Connecting the peripheral components to the AEC 22
4.5.2 Configuring the AEC hardware and network 25
4.5.3 Configuring the AEC software 26
5 Resources and further reading 27
Glossary 28
Index 30