Specifications
19
ARS-2021/2021S Copy Smart Plus
Two different main operation procedure are required to install the duplicatior with:
1. With hard drive installed
Duplicator will detect the hard drive and create partitions for it (each partition
will have 1G capacity, e.g. 10GB Hard Disk will probably have 10 partitions
which it is included 9 working partitions and 1 TEMP partition)
Use the Select Source to set the hard drive being the target source.
Then select which partition to store the data in the “Image” in Main Menu.
If there is no data stored in present/selected partition of hard drive, press the
arrow button to select “load” function and place the master disc into the CD-
ROM, then press “ENT” button to load data into the present/selected
partition. Change another master disc for data loading. Master data can be
stored in different partition switch to that particular partition (Please refer to
Image) for loading.
Switch to Copy function by pressing arrow button. Place blank CD-R or CD-
RW discs into all the CD writers. Press “ENT” button to strat copying when
all writers detect the CD discs.
When Copy is completed on all CD writers, those CD discs passed will be
ejected automatically (default setting: Passed discs will be ejected. This can
be changed according to your setting). For continuous duplication, place
additional blank discs into the CD writers and repeat the above procedures.
Failed disc(s) will remain in respective CD writer(s) (Default setting: Failed
disc NOT ejected. This can be changed according to your need). Press
each eject button on the CD writer to eject disc manually.
The duplicator will prompt you an error message when you try to copy a
partition that contains no data. In this case, please switch to “Load” function
to load data first.
Do not press any button on duplicator during operation as interruption/
termination of operation will cause error and might cause the duplicator to
hang up (depend on writers installed). The CD-R discs will be ruined and
can not be used again.