Specifications

ARS-2030/2032 Copy Smart Plus

Chapter 2 Installation Procedure

When you get CD Copy Smart Plus, you could find the package in the following

possibilities: controller only; whole duplicator without writer installed & completed

duplication system.

2.1 Contorller only

1. Before the installation, please prepare the necessary devices as following:

!CD-ROM drive

!CD-R/RW drive

!IDE case (5~10-bay chassis suggested).

!Hard drive and mobile rack (IDE-bus hard drive-Option)

!Switching power supply (300W suggested).

2. After the preparation as above and make sure that:

!All IDE devices must be in Master mode.

2.2 Whole duplicator without writer installed

!Unpack the package of the duplicators.

!Prepare the CD-R/RW writers according to the recommendation of list

for installation. Please check for unlisted CD-RW writer if needed from

supplier.

!Assemble the duplicator according to your need.

!Make sure that the voltage setting is correct.

2.3 Completed duplication system

!Unpack the package of duplicators.

!Check the entire unit to see if there is any mal-function or damage found.

!Make sure that the voltage setting is correct.

!Hard drive is an optional installation to the duplication system.