Installation Guide

DS#8001

Description:"Wall/Door"Mount"Bumper

Material:"Stainless"Steel"and"Rubber"

Size:5(Diameter)"38"x"(Height)"7 5m m"

Finishing:"Polished"Stainless"Stee l"or"Brushed"Stainless"Steel

Packaging:51pc+Fasteners/polyb a g

Installatio n 5In s t ru c tio n s:

1." Make"a"pencil"mark"of"a"desired"spot"where"the"bumper"fasteners"will"be"installed"on"the"baseboard"

of"the"wall"or"door."

2." At"those"spots,"drill"holes"for"the"screws.""If"wall"is"masonry,"drill"hole"with"carbide"bit"and"insert"

anchor."

3." Insert"bumper"scre w "in to "p o sitio n ."

*Tip:""Wall/Door"mount"bu m pers "ma y"also"fun ction"as"a "hang er.

PAGE 1
DS-8001 Description: Wall/Door Mount Bumper Material: Stainless Steel and Rubber Size: (Diameter) 38 x (Height) 75mm Finishing: Polished Stainless Steel or Brushed Stainless Steel Packaging: 1pc+Fasteners/polybag Installation Instructions: 1. 2. 3. Make a pencil mark of a desired spot where the bumper fasteners will be installed on the baseboard of the wall or door. At those spots, drill holes for the screws.