User Manual
Table Of Contents
- COPYRIGHT
- HISTORY
- 1.Summary
- 2.Steps to initiate the device
- 3.Introduction
- 4.Device specifications
- 5.How TRK210 and TRK230 work
- 6. How to use TRK devices
- 7. Back cover removal
- 8.SIM card installation
- 9.Battery installation (only for TRK210 model)
- 10.Battery recharging (only for TRK230 model)
- 11.Human interfaces
- 12. Autotest and key provisioning
- 13. Inmolecular
- 14. TRK2XX connection configuration
- 15. TRK2XX advanced configuration
- 16.Accent Systems Support
- 17.FCC
- 18.CE-RED statements
- Bluetooth
TRK2XX Initiation Manual
11
Figure 1 - TRK back cover bolts position.
The steps to reinstall the back cover are:
1. Check the back cover position against the top part of the TRK device. See Figure 2 for
more details of correct alignment.
2. Before to close check that the o-ring seal is in the correct position. The o-ring have to
be placed all over the TRK top part edge.
3. Place the back cover over top part and screw the 4 HEX screws.
8. SIM card installation
TRK2XX series uses cellular technology to communicate with cloud based platform. To enable
this communications is mandatory to insert a SIM card. The steps to install a sim card are:
1. Remove back cover as described in the section number 3 of this document.
2. Open SIM card holder as is shown in the figure 3.
1.5mm HEX key