User's Guide

Accent 800 User’s Guide-Empower 26
Mounting the IR Reflector on a Non-Dedicated
Device
Note: Infrared (IR) functionality is only available on non-dedicated devices.
Your device emits infrared signals from the IR area on the back of the
device. The optional IR reflector allows the user to better “aim” those
signals from any position. If you have the IR reflector, follow these
instructions to attach it to the device.
The IR reflector can be mounted on the device handle, port cover, or
NuPoint module, depending on which is already attached to your
device. The reflector kit includes the reflector, two short screws, and
two long screws.
1. Using a Phillips screwdriver, remove the appropriate screws, as shown.
Handle: If the handle is attached to your device and the front device
frame is held in place with screws, remove the top frame screws.
NuPoint Module: If a NuPoint module is attached to your device,
remove the two inside screws from the module.
Port Cover: If a port cover is attached to your device, and the front
device frame is held in place with screws, remove the top frame screws.